TDUQL

Electrical Machine Design and Electrical Drafting: Schedule and Completion Requirements

This page explains when Electrical Machine Design and Electrical Drafting is offered and when its two credits must be completed.

When the course is offered

For the 2025 academic year at Tokyo Senju Campus, in the Faculty of Engineering's Department of Electrical and Electronic Engineering, Electrical Machine Design and Electrical Drafting is a fourth-year, second-semester course. In the 2026 academic year, within the DP1 Power Electronics and Electrical Machines field of the Faculty of Engineering Second Division's Department of Electrical and Electronic Engineering, it is also placed in the fourth year, second semester. The course is worth 2 credits.

Required completion

Electrical Machine Design and Electrical Drafting is a required 2-credit course in the Design and Drafting category. For the 2025 academic year, it must be completed under the requirements shown in Table A. During enrollment, the course must be completed because it cannot be made up by passing an examination, and completion through the auditing-student system is subject to limitations. The same 2-credit course is also specified as mandatory in the Design and Drafting category for the 2026 academic year.

Official sources

The following official Tokyo Denki University materials were used to prepare this page.